Network 206 Test homework help Archives

Network 206 Test homework help

Question 1.1. (TCO 1) What additional information is contained in the 12-bit extended system ID of a BPDU? (Points : 6)

VLAN ID Host address MAC address Port ID

Question 2.2. (TCO 1) EIGRP is a _____. (Points : 6)

link-state routing protocol proprietary routing protocol protocol that works well in smaller networks statistical routing protocol

Question 3.3. (TCO 1) _____ is enabled by default. (Points : 6)

STP EtherChannel PortFast VLAN 100

Question 4.4. (TCO 2) How would you describe an EtherChannel implementation? (Points : 6)

EtherChannel supports between two to 10 separate links. It increases the chance of a spanning-tree loop. A trunked port can be part of an EtherChannel bundle. EtherChannel operates only at layer 2.

Question 5.5. (TCO 2) You have configured EtherChannel . Which command will display the group used? (Points : 6)

show interface port-channel3 show etherchannel summary show etherchannel port-channel show interface g0/1 etherchannel

Question 6.6. (TCO 2) The configuration of which other protocol can affect or cause problems with the EtherChannel configuration? (Points : 6)

LACP DTP STP DTP and STP

Question 7.7. (TCO 3) _____ is a global organization that certifies the interoperability of 802.11 products from different vendors. (Points : 6)

FCC IEEE ITU-R Wi-Fi Alliance

Question 8.8. (TCO 3) A(n) _____ is used in enterprise deployments to manage groups of lightweight access points (Points : 6)

access point RADIUS authentication server WLAN controller Wireless switch

Question 9.9. (TCO 3) Which technology is used to increase the available bandwidth for the wireless network? (Points : 6)

MIMO Mixed mode OFDM WPS

Question 10.10. (TCO 4) Which OSPF state is reached when the network has converged? (Points : 6)

Converge Exchange Full Two-Way

Question 11.11. (TCO 4) _____ is a link-state routing protocol. (Points : 6)

EIGRP OSPF RIPv2 RSTP

Question 12.12. (TCO 4) Why would OSPF routing protocol authentication be enabled on a network? (Points : 6)

To activate IPsec for IPv6 To share routing information with neighbors in a secure manner To block unauthorized access to the router To activate LACP

Question 1.1. (TCO 4) How might one describe OSPF type 5 LSAs? (Points : 6)

They are used to update routes between OSPF areas. They are called autonomous system external LSA entries. They are called router link entries. They are used where there is an elected DR in multi-access networks.

Question 2.2. (TCO 4) How might one describe OSPF type 3 LSAs? (Points : 6)

Question 3.3. (TCO 5) EIGRP _____ packets have a need for specific information. (Points : 6)

Hello Query Update Reply

Question 4.4. (TCO 5) The EIGRP hello packets are sent using the _____ protocol? (Points : 6)

TCP reliable RTP UDP unreliable RTP

Question 5.5. (TCO 5) What is a benefit of EIGRP? (Points : 6)

It is an open standard. Automatic route summarization of all routes Quickly adapts to alternate routes for rapid convergence It does not use loopback addresses.

Question 6.6. (TCO 5) A network engineer issues the maximum-paths command to configure load balancing in EIGRP. Which CLI mode is he in? (Points : 6)

Privileged mode Global configuration mode Router configuration mode Interface configuration mode

Question 7.7. (TCO 5) The quad zero static default route _____. (Points : 6)

is not used with EIGRP should be configured on the router facing the ISP is distributed for IPv6 with the redistribute IPv6 static command is represented as 0.0.0.0 255.255.0.0

Question 8.8. (TCO 5) _____ is also called the bit bucket. (Points : 6)

Loopback Link-Local Null0 interface EIGRP process link

Question 9.9. (TCO 6) On Cisco routers, where is the IOS stored? (Points : 6)

Flash memory NVRAM ROM tftp server

Question 10.10. (TCO 6) What is the tftp server used for? (Points : 6)

It allows for management of the router from a remote location. It is required for VPN connectivity for workers who must travel. It is used as a backup location for the IOS. It holds the IOS license agreement.

1. (TCO 1) Name the characteristics which would more likely be considered in purchasing an access layer switch, as compared to buying switches that operate at the other layers of the Cisco hierarchical design model. (Points : 14)

Question 2.2. (TCO 2) What is a benefit of using the channel-group 2 mode passive interface configuration command? (Points : 14)

Question 3.3. (TCO 3) Describe in detail the WiGig standard, in your own words. (Points : 14)

Question 4.4. (TCO 4) What is the criteria for selecting the OSPF router ID that uniquely identifies a router in an OSPF domain? Explain the process of selecting the router ID. (Points : 14)

1. (TCO 4) In your own words, list and describe the four steps to implementing multi-area OSPF. (Points : 14)

Question 2.2. (TCO 5) What are the three default EIGEP ADs with the source of route. List them in the order of preferred administrative distance with the best AD first. (Points : 14)

Question 3.3. (TCO 5) Write all the necessary commands to support MD5 authentication of the CHG_Secure keychain with a key string of Pep$R5. You must also include the IOS command prompts in front of the commands. Assume that you are already in global config mode. Rtr1(config) # (Points : 14)

Posts